Tipper Operation; Isolation Switch - Opel Automobile Owner's Manual

1-4 Tipper

Tipper operation

9 Warning
The operator must remain at the
control to ensure tipping and
lowering are performed correctly.
Do not allow anyone in or onto the
tipper body whilst operating the
tipper.
Ensure the vehicle is on level
ground and that the tipper body
can be raised to the maximum
height without fouling overhead
obstructions.
The tipper body has two locking pins
with each pin having a locator on its
upper edge. The locking pins are
used to obtain any one of the three
tipping positions.
Caution
The tipper must not be operated with
locking pins incorrectly installed.
Pins installed diagonally opposite or
in both front pivot positions will result
in damage if tipping is attempted!
To insert locking pin into pivot, ensure
the handle and locator are facing up.
Rotate the locking pin away from the
upright position to ensure the pin is
secured.

Isolation switch

The system must be activated using
the isolation switch located on the left
side tipper frame behind the cab.
Insert and turn the isolator key in the
switch.
When the tipper is not in use, turn the
isolator key to the off position and
remove it.
Back to overview