Opel Automobile Owner's Manual page 25

Press and hold the set button again
and press the back or next button.
Then release the set button.
The heating duration is displayed
and the flame symbol flashes.
Change heating duration using the
back or next button. The value can be
set from 10 to 60 minutes. Press set
to confirm.
The preset heating duration for
programmed mode is stored and the
display disappears.
Activating departure times
Departure times must be activated
individually. Only one departure time
can be activated at a time.
Press the set button until the desired
departure time and memory location
is displayed. After a brief delay, the
memory location to be activated
flashes in the display along with the
flame symbol, until the heater starts.
Deleting departure times
While the next preset memory
location to be activated is flashing in
the display along with the flame
symbol, press the set button.
The flame symbol and 1, 2 or 3
extinguishes.
Resetting
If the power supply is interrupted or
the battery voltage is too low, the
current time and all programmed
departure times are lost: The unit will
need to be reset.
To reset time: With heater off, press
and hold the set button, press the
back or next button, then release set.
Time of day is displayed and the
clock symbol flashes.
Set the time using the back or next
button and press set. The time is
stored and the display disappears.
Auxiliary heating systems
Air heater
The Webasto engine-independent
auxiliary air heater, located under the
vehicle, provides additional heating
for the rear passenger compartment
during driving and while the vehicle is
parked.
The heater can be programmed to
start at a specific time or switched on
for immediate use.
The heater is controlled with a control
unit on the instrument panel or with a
radio remote control 3.
When the heater unit is on, fuel
consumption increases. Switch off
the unit whenever it is not required.
The heater will cease to operate if the
vehicle fuel level drops too low.
The heater unit stops automatically
after a maximum 2 hours of
continuous use.
To ensure efficient performance, the
heater must be operated briefly once
a month.
4-3
Back to overview