Connections and Installation
When connecting an Ethernet cable
Connect the Ethernet cable as shown in the following figures.
•
If the distance from the end of the connector to the bend in the cable is 30 mm (1
Ethernet cable
•
If the distance from the end of the connector to the bend in the cable is more than 30 mm (1
Remove the cable cover (A) from the back of the stand, and then run the Ethernet cable so the stand lies
flat on a horizontal surface.
98
Operating Instructions
/
30 mm (1
in)
3
16
or less
Ethernet cable
A
/
in) or less
3
16
/
in)
3
16
Document Version 2011-09