Change The Pin Code; Access The Answering Machine; Base Station - Philips CD190 User Manual

1
Press MENU/OK.
2
Select [ANSW MACHINE] > [REMOTE
ACC.], then press MENU/OK to confirm.
3
Select [ON]/[OFF], then press MENU/OK
to confirm.
» The setting is saved.

Change the PIN code

1
Press MENU/OK.
2
Select [ANSW MACHINE] > [REMOTE
ACC.] > [CHANGE PIN], then press
MENU/OK to confirm.
3
Enter the old PIN, then press MENU/OK
to confirm.
4
Enter the new PIN code, then press
MENU/OK to confirm.
5
Enter the new PIN code again, then press
MENU/OK to confirm.
» The setting is saved.

Access the answering machine

remotely
1
Make a call to your home number with a
touch tone phone.
2
Enter # when you hear the announcement.
3
Enter your PIN code.
» You now have access to your
answering machine, and you can now
listen to the new messages.
Note
•
You have 2 chances to enter the correct PIN code
before your phone hangs up.
4
Press a key to carry out a function. See the
Remote access commands table below for
a list of available functions.
EN
28
Note
•
When there is no message, the phone hangs up
automatically if no key is pressed for 8 seconds.
Remote access commands
Key Function
1 Repeat the current or listen to the
previous message.
2 Listen to messages.
3 Skip to the next message.
6 Delete the current message.
7 Switch the answering machine on.
(not available when you listen to the
messages).
8 Stop listening to the message.
9 Switch the answering machine off.
(not available when you listen to the
messages).
Behavior of the LED display on the

base station

The table below shows you the current status
with different LED display behavior on the base
station.
LED Message status
display
Steady on • There is no new message and
the memory is not full.
• The handset is switched on.
• Enter the paging mode
Flashing • There is a new message and the
memory is not full.
• There is an incoming call.
• Recording an incoming mes-
sage/announcement.
• Message playback.
• Remote access/listen to mes-
sages from the handset.
Flashing • There is no new message and
(Fast) the memory is full.
• Enter the registration mode