Charge The Handset; Check The Battery Level; What Is Standby Mode; Pin Code - Philips CD190 User Manual

1
Press MENU/OK.
2
Select [ANSW MACHINE] > [REMOTE
ACC.] > [CHANGE PIN], then press
MENU/OK to confirm.
3
Enter the old PIN, then press MENU/OK
to confirm.
4
Enter the new PIN code, then press
MENU/OK to confirm.
5
Enter the new PIN code again, then press
MENU/OK to confirm.
» The setting is saved.

Charge the handset

Place the handset on the base station to
charge the handset. When the handset is
placed correctly on the base station, you hear a
docking sound.
» The handset starts charging.
Note
•
Charge the batteries for 8 hours before first use.
•
If the handset becomes warm when the batteries are
being charged, it is normal.
You can activate or deactivate the docking tone
(see 'Set the docking tone' on page 20).
Your phone is now ready to use.

Check the battery level

The battery icon displays the current battery
level.
When the handset is off the base
station/charger, the bars indicate
the battery level (full, medium and
low).
When the handset is on the base
station/charger, the bars flash until
charging completes.
The empty battery icon flashes.
The battery is low and needs
recharging.
The handset turns off if the batteries are empty.
If you are on the phone, you hear warning
tones when the batteries are almost empty. The
call gets disconnected after the warning.

What is standby mode?

Your phone is in standby mode when it is idle.
The standby screen displays the handset name
or date and time, and handset number.
Tip
•
Press and hold MENU/OK to switch between the
handset name and date and time display.
EN
9