KitchenAid Sculptura KUDR24SE Use & Care Manual page 27

Before calling for service...
If your appliance fails to operate, review the following list and the "Solving Common
Dishwashing Problems" section on pages 24-26 before calling your dealer. This could
save you the cost of a service call.
Dishwasher is not operating properly
PROBLEM CHECK THE FOLLOWING
Dishwasher does
not run or stops
during a cycle
Is the door tightly closed?
Has the cycle been set correctly? See page 7.
Is Child Lock on? See page 18.
Has a household fuse or circuit breaker blown or tripped?
Is the water supply turned on?
If the motor has stopped because of an overload, it will automatically
reset itself within a few minutes. If the motor does not start, call for service.
Dishwasher will Is the overflow protection float stuck in "up" position? It should move up
not fill and down freely. Press down to release. See page 21.
Dishwasher Is the incoming water temperature low? The dishwasher will run longer
seems to run while water automatically heats or if the High Temp. Wash option has
too long been selected. Set your water heater to ensure that the water entering
the dishwasher is at least 120°F (49°C).
Water remains Wait for the cycle to finish. A small amount of water remaining is normal•
in dishwasher Check the drain air gap (if installed). If it is clogged, follow the manu-
facturer's cleaning instructions. See page 23.
Detergent Use fresh detergent and store it tightly closed in a cool, dry place.
remains in Throw away any lumpy detergent.
covered Wait for the cycle to complete itself.
detergent cup
Overflow protection float should move up and down freely. See page 21.
White residue Some detergents foam a lot and can build up on the access panel•
appears on front Try using less detergent or a different brand to reduce foaming
of access panel and eliminate buildup.
Odor in the Run a Rinse Only cycle at least once or twice a day until a full load
dishwasher is accumulated•