KitchenAid Sculptura KUDR24SE Use & Care Manual page 25

Undercounter dishwasher
Hide thumbs Also See for Sculptura KUDR24SE:
Table of Contents

Advertisement

Dishes are not cleaned completely
(cont.)
PROBLEM
Spoffing and
_mlng(cont.)
Silica film
or etching
(silica film is
a white milky
looking
deposit;
etching is a
cloudy film)
CAUSE
SOLUTION
Use of ineffective
detergents
Insufficient fill due to low
Water pressure
For effective cleaning, use fresh dishwasher
detergent and store it tightly closed in a cool,
dry place. Throw away any lumpy detergent.
Your home water pressure should be 20 to
120 psi (138 to 828 kPa) for proper dishwasher
fill. You may need a booster pump on the water
supply if the pressure is too low.
Rinse agent not used
A water chemical reac-
tion with certain types of
glassware - usually
caused by some combina-
tion of soft or softened
water, alkaline washing
solutions, insufficient
rinsing, excessive
detergent, and over-
loading the dishwasher
Fill the rinse agent dispenser. See the instruc-
tions on page 15.
You may have to hand wash these items to
eliminate this problem completely. Silica film
and etching are permanent marks and cannot
be removed. To slow down the reaction, you
can try using as little detergent as possible and
a liquid rinse agent. Also, underload the dish-
washer to allow thorough rinsing, and use the
Energy Saver Dry option.
White spots
Seasoning removed by
Reseason your cookware after dishwasher
on eookware
dishwasher detergents
washing. See cookware manufacturer's instruc-
with non-
tions, or coat pan with cooking oil and wipe
stick finish
clean with a paper towel.
Dishes do not dry completely
PROBLEM
CAUSE
SOLUTION
Dishes are
Water temperature is
Set your water heater to ensure that the water
not dry
too low
entering the dishwasher is at least 120°F (49°C).
See page 20 for recommended procedure under
"Energy saving tips".
Water does not drain off
of dishes
Rinse agent not used
Do not overload the dishwasher so that the
water can drain off the dishes adequately, and
use a liquid rinse agent to help speed drying.
See pages 8-11 for proper loading instructions.
Do not use the Energy Saver Dry option.
Fill the rinse agent dispenser. See page 15 for
instructions.
Plastics
Energy Saver Dry
option used
Some plastics might need to be towel dried.
Do not use the Energy Saver Dry option on the
next load of dishes.

Advertisement

Table of Contents
loading

Table of Contents