Waste Disposal; Motor Oil Disposal - Exmark Turf Tracer HP TT3615KA Operator's Manual

STANDARD PISTOL GRIP HANDLES
3. Make this adjustment for both sides.
e) Tracking Adjustment
1. Stop engine and wait for all moving parts to stop. Raise the rear of the
2. Run the unit and observe the tracking on a level, smooth, hard surface
3. If the unit tracks to one side or the other, turn the quick track knob. Turn
5.2.7 Hydro Pump Spring Tension Setting
a) For medium or heavy duty drive conditions such as operation with a sulky on
steep slopes, a higher spring force may be required on the hydro pump
control arms to prevent the drive system from stalling.
b) For a heavier drive setting, relocate the spring anchor link to either the
"medium" or "heavy duty" positions as shown in Figure 17. The spring
anchor links are attached to the upper rear corner of the hydro drive shields
on the left and right hand sides of the machine.
Note: In the "medium" or "heavy duty" positions, the drive lever
the upper handle will also be increased.

6. WASTE DISPOSAL

6.1 MOTOR OIL DISPOSAL

Engine oil and hydraulic oil are both pollutants to the environment. Dispose of used oil at a
certified recycling center or according to your state and local regulations.
FIGURE 16
DRIVE LEVER AND LATCH IN NEUTRAL POSITION
machine, remove jack stands and carefully lower the machine to the
ground. (Check the drive tire pressure and tire circumference. See
5.1.11.)
such as concrete or asphalt.
the knob right to "steer" right; turn the knob left to "steer" left.
FIGURE 17
HYDRO PUMP SPRING TENSION SETTING
- 37 -
ECS HANDLES
forces at