Jenn-Air JCD2389DTB Guide Installation Instructions Manual page 3

I_L WARNING --. When using your appliance, always follow basic precautions, including [
I
the following:
I
• Use the refrigerator only for its intended purpose.
• To prevent possibility of hazard due to electrical shock,
never plug the refrigerator into a receptacle which has
not been grounded adequately and in accordance with
the local and national electrical codes. See the _k warn-
ing and grounding instructions below.
• Unplug the refrigerator before cleaning or replacing a
light bulb.
• In case of power failure, minimize door openings. If the
power failure is of a long duration, protect the food by
placing blocks of dry ice on top of the packages or check
with a local frozen foods locker about temporary stor-
age. Frozen foods which have thawed completely should
not be refrozen and should be discarded.
• Any electrical service cord that becomes frayed or dam-
aged should be immediately repaired or replaced. Never
unplug your appliance by pulling on the power cord.
• Your refrigerator should not be operated in the presence
of explosive fumes.
• Children should not climb, hang or stand on the shelves
of this refrigerator.
Impor/an_
Child entrapment and suffocation are
not problems of the past. Junked or abandoned
refrigerators are still dangerous.., even if they will
sit for "'just a few days?' If you are getting rid of
your old refrigerator, plea._ follow the instructions
below to help prevent accidents.
• Take off the doors.
• Leave the shelves in place _ that children may not
easily climb inside.
Jk WA//NIN6 -- This appliance is designed to. operateonaml 115volt, 15amp, 60cycle I
line. There should be a separate, grounded circuit serving this appliance only. Do not use an
extension cord. Do not use any device that will alter the electrical performance of this appliance.
This appliance is equipped with a three-pronged grounding plug for
your protection against possible electrical shock hazards, It must be
plugged into a grounding receptacle. Where a standard two-prong
wall receptacle is encountered, it is the personal responsibility and
obligation of the customer to have it replaced with a properly
grounded three-prong wall receptacle. Do not under any circum-
stances, cut or remove the third (ground) prong from the power cord.
Do not use an adapter plug. Do not use an extension cord.
POWER SUPPLY CORD
WITH 3-PRONG
GROUNDING PLUG
Save These Instructions
GROUNDINGTYPE
WALL RECEPTACLE