GE JGB3000 Owner's Manual & Installation Instructions page 48

v
w
i
w,_ La]
v A
w . .
_ v
.-- L
iiiiiH/l! iiii!l il
i
0
E
0
Before you call for service...
Troubleshooting Tips
Possible Causes What To Do
Display goes blank A fuse in your home may be • Replacethe fuse or reset the circuit breaker.
(onsomemodels) blown or the circuit breaker
tripped.
The clock is turned off so that it • Seethe Using the clock and timer section.
does not show in the display.
Display flashes Power failure. • Resetthe clock.
(onsomemodels)
Unable to get the Oven control pads were • The Bake and Broil Hi/Lo pads must be touched at
display to show '_F" not touched properly, the same time and held for 3 seconds.
(onsomemodels)
Power outage, Power outage or surge. • Resetthe clock. If the oven was in use, you must reset
clock flashes it by touching the Clear/Offpad, setting the clock and
(onsomemodels) resetting any cooking function.
"Burning" or "oily" odor This is normal in a new oven • To speed the process,set a self-clean cycle for a
emitting from the vent and will disappear in time. minimum of 3 hours. Seethe Using the self-cleaning
oven section.
Strong odor An odor from the insulation • This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise A cooling fan may automatically • This is normal. The cooling fan will turn off and on.
turn on and off to cool
internal parts.
Drawer does notslide The drawer is out of alignment. • Fullyextend the drawer and push it all the way in.
smoothly or drags Seethe Careand cleaning of the range section.
Drawer is overloaded or load • Reduceweight. Redistribute drawer contents.
is unbalanced.
48