GE JGB3000 Owner's Manual & Installation Instructions page 28

Care and cleaning of the range.
Usea sewing needleor twist-tie
to unclogthe small hole in the burner
head.
Burner Caps and Heads
NOTE:Before removing the burner caps
and heads, remember their size and
location. Replace them in the same
location after cleaning.
Burner caps
Lift off when cool. Wash burner caps
in hot, soapy water and rinse with clean
water. You may scour with a plastic scouring
pad to remove burned-on food particles.
Burner heads
For proper ignition, make sure the small hole
in the section that fits over the electrode is
kept open. A sewing needle or wire twist-tie
works well to unclog it.
Theslits in the burner heads must be kept
clean at all times for an even, unhampered
flame.
Cloggedor dirty burner ports or electrodes
will not allow the burner to operate properly.
Any spill on or around an electrode must
be carefully cleaned. Take care to not hit
an electrode with anything hard or it could
be damaged.
You should clean the burner caps and
burner heads routinely, especially after bad
spillovers,which could clog the openings
in the burner heads. Lift offwhen cool.
To remove burned-on food, soak the burner
heads in a solution of mild liquid detergent
and hot water for 20-30 minutes. For more
stubborn stains, use a toothbrush.
After cleaning
Before putting the burner caps and heads
back, shake out excess water and then dry
them thoroughly by setting in a warm oven
for 30 minutes.
NOTE:Do not usesteel wool or scouring
powders to clean the burners.
Replacement
Replaceburner heads over the electrodes
on the cooktop, in the correct locations
according to their size.
On some models:
Smn_ _1 chae; d
Q •
Fron!otrang,
Largehead .......... i_arge head
and cap and cap
On some models:
Medium head smal head
and cap andcap
Front0 r e"
i i!il
Medium head Large head
andcap andcap
Hake sure the slot in the burner head
is positioned over the electrode.
Replacethe matching size caps onto
the heads.
Hake sure that the heads and caps ore
replaced in the correct locations.
NOTE:On some models, the burners are
all the same size and power.
28