Table of Contents
Advertisement
Single
radiant
surface
elements
The cooktop has 2 SINGLE radiant surface elements: the
left rear position (Figure 1) and the right
rear position
(Figure 1).
To Operate the Single Radiant Surface Elements
1.
Place correctly sized cookware on the radiant surface
element.
2.
Push in and turn the surface control knob in either
direction to the desired setting (Figure 2). Start most
cooking operations on a higher setting and then turn
to a lower setting to finish cooking. Each surface
element provides a constant amount of heat at each
setting. A glowing red surface heating area extending
beyond the bottom edge of the cookware indicates
the cookware is too small for the surface heating
area.
3.
When cooking has completed, turn the surface
control knob to OFF before removing the cookware.
The surface "Element
On" indicator lights will glow
when one or more elements are turned on. A quick
glance at these indicator lights when cooking is finished
is an easy check to be sure all surface elements are
turned off.
See Recommended Setting for Surface Element table on
Figure 1
OFF
1o
hi
2
8
3
7
4
6
reed
Figure 2
; =
Do not place plastic items such as salt and
pepper shakers, spoon holders
or plastic
wrappings
on cooktop when it is in use. These
items could melt or ignite. Potholders, towels or
wooden spoons could catch fire if placed too close
to the surface elements.
-
Do not allow
aluminum
foil, or ANY material
that can melt to make contact with the
ceramic glass cooktop.
If these items melt on
the cooktop they will damage the ceramic cooktop.
Radiant surface elements may appear to have cooled
after they have been turned OFR The hot surface
indicator
light will turn ON and will continue to glow
until the glass cooktop has cooled down to a moderate
level. The glass surface may still be hot and burns
may occur if the glass surface is touched before the
indicator light has turned OFR The message may
remain on even though the controls are turned OFR
Advertisement
Table of Contents
