Table of Contents
Advertisement
TO SET THE
CLOCK
When the range is first plugged in, or when the power
supply to the range has been interrupted,
the display will
flash "12:00".
1.
Press CLOCK briefly (do not hold pad down).
2.
Within 5 seconds, press and hold the A
or V
until
the correct time of day appears in the display.
Note= The clock cannot be changed during any Bake
or Self-Clean cycle.
-
The time of day must first be set in order to operate
the oven.
-
To turn the time of day display OFF or ON in the
display press CLOCK and hold for 15 seconds (the
control will beep once) and then release. This feature
does not remove the set time of day from the memory
of the control. When the display is turned OFF the time
of day will reappear for a few seconds any time the
CLOCK pad is touched,
FOR A SILENT
CONTROL
PANEL
When choosing a function, a beep will be heard each
time a pad is pressed. If desired, the control can be
programmed for silent operation. Press and hold START
TIME. After 7 seconds, the control will beep once. This
will block the controls from sounding when a pad is
pressed. To return the sound, press and hold DELAY
START again for 7 seconds until the control beeps once.
TO SET THE MINUTE TIMER'
I. Press TIMER
on=off.
2.
Press the A to increase the time in one minute
increments. Press and hold the/_
to increase the
time in 10 minute increments. The timer can be set
for any amount of time from 1 minute to 11 hours
and 59 minutes.
Note: If the V
pad is pressed first, the timer will
advance to 11 hours and 59 minutes.
3.
The display shows the timer countdown in minutes
until 1 minute remains. Then the display will
countdown in seconds.
4.
When the set time has run out, the timer will beep 3
times. It will then continue to beep 3 times every 60
seconds until TIMER on=off is pressed.
- The indicator light located above the TIMER on=off
pad will glow while the minute timer is active.
- The minute timer does not start or stop cooking.
It
serves as an extra timer in the kitchen that will beep
when the set time has run out. The minute
timer
can be used alone
or during any of the other oven
functions.
When the minute timer is in use with any
other function,
the minute timer will be shown in the
display. To view other functions,
press the pad for that
function.
To Change
the Minute
Timer
while
it is in use"
While the timer is active and shows in the display, press
and hold the/_
or V to increase or decrease the time.
To Cancel the Minute Timer before the set
time has run out:
Press TIMER on=off,
Advertisement
Table of Contents
