Exmark Metro 26 Operator's Manual page 21

3.3.9 Using the Grass Bag:
Occasionally, you may wish to use the grass bag for bagging extra long grass,
lush grass, or leaves.
a) Installing the Grass Bag:
1. Stop the engine and wait for all moving parts to stop.
2. Open the rear door.
3. Set the bag frame onto the bag support tabs.
4. Lower door onto bag.
b) Mowing with the Grass Bag:
POTENTIAL HAZARD
♦ A worn grass bag could allow small
stones and other similar debris to be
thrown in the operator's or bystander's
direction.
WHAT CAN HAPPEN
♦ Thrown objects can result serious
personal injury or death to the operator or
bystanders.
HOW TO AVOID THE HAZARD
♦ Check the grass bag frequently. If it is
damaged, install a new Exmark
replacement bag.
Cut the grass until the bag is full.
NOTE: Do not overfill the bag.
c) Removing the Grass Bag:
1. Stop the engine and wait for all moving parts to stop.
2. Raise the discharge door.
3. Grasp the bag handle and lift the bag off the lawn mower.
4. Gradually tip the bag forward to empty the clippings.
5. To install the bag, refer to section 3.3.9 a).
FIGURE 8
WARNING
16