Advertisement
Available languages
Available languages
[] Supplied
Accessories
owner's
manual
quick start guide
(1EMN24300)
(1EM N24640)
remote control
registration
card
Phillips pan screw for
(NH000UD)
(1EMN24701)
attaching
the stand x 4
(FPH34200)
batteries
(AAA x 2)
. If you need to replace these accessories, please refer to the part No. with the illustrations
and call our toll free
customer
support
line found on the cover of this manual.
[] Attaching
the Stand
You must attach the stand to the unit to have it as a table top unit. Be sure the front and rear of the stand match the proper
direction.
Spread a thick and soft cloth over a
table as shown below.
Placethe main unit face down onto it.
Make sure not to damage the screen.
At leasttwo people are required at
this step.
_
Align the 2 stand hooks with the two
hooks under the bottom of the main
unit (shown by arrow _)),then
slide
the stand in the direction
as shown
by arrow @ until it stops and the 4
mounting
holes are aligned.
Make sure not to put the AC power
cord between
the stand and the
unit.
@
_
Drive Phillips pan screws in the 4
threaded
holes at the bottom
of the
stand until they are tight.
_screw holes\
To remove
the stand from
this unit
Unscrew the Phiflips pan screws indicated by above "_3_"screw
holes. After the screws are removed pull the stand up toward
the rear of the unit. Be careful not to drop the stand when you
remove it.
Note:
• When attaching
the stand, ensure that aft screws are tightly
fastened.
If the stand is not properly
attached,
it could cause the unit to fall,
resulting
in injuries as well as damage
to the unit.
• Make sure to use a table which can support
the weight
of this unit and is larger than this unit.
• Make sure the table is in a stable location.
[]Symbols
Used in this Manual
The following
is the description
for the symbols used in this manual. Description
refers to:
: Analog TV operation
: Digital TV operation
. If neither
symbol appears
under the function
heading, operation
is applicable
to both.
EN
Advertisement
