Locations Ofthe Burners; Placement O Fburnerheadsandcaps - Electrolux E36GC70FSS1 Use & Care Manual

Surface Cooking
LOCATIONS O FTHEBURNERS
[] [] [] m I [] [] [] _ I U [] I [] m U
The 30" cooktop isequipped with different sized burners.
The surface burners are located on the cooktop as follows (See Figure):
a 5 000 BTU (natural gas) burner located at the right rear position;
a 9 500 BTU (natural gas) burner located at the left rear position;
a 16 000 BTU (natural gas) burner located at the left front position;
and a 17 000 BTU (natural gas) burner located at the right front position.
The 36" cooktop is equipped with different sized burners.
The surface burners are located on the cooktop as follows (See Figure):
a 5 000 BTU (natural gas) burner located at the right rear position;
two 9 500 BTU (natural gas) burners located at the left and center
rear positions;
a 16 000 BTU (natural gas) burner located at the left front position;
and a 17 000 BTU (natural gas) burner located at the right front
position.
!1 [] [] I! I!
[]
30"cooktop
36"cooktop
PLACEMENT OF BURNERHEADSAND CAPS
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] Ill [] [] [] [] [] []
Place burner head over each gas orifice, matching the head with the
orifice size. Be careful not to damage the electrode while placing
the burner head over the orifice. Make sure electrode fits correctly
into slot in burner head. Place a burner cap on each burner head,
matching the cap size to the head size. The cap for each burner has an
inner locating ring which centers the cap correctly on the burner head. Be
sure that all the burner caps and burner heads are correctly placed
BEFORE using your appliance.
Make sure each burner cap is properly aligned and level.
Turn the burner on to determine if it will light, if the burner does not light,
contact a Service Center. Do not service the sealed burner yourself.
i
i
_urner_,
Electrod
i_i_i_i_i/;i;ii_i_i_i_;iiiiiii_iiiiiii_iiiiiiiiiiiiiiiiiiiiiiiiiii/iiiii!i!i!
i'ii_ii/itiii:i:i