Electrolux Wave-Touch EWFLS70JMB0 Use & Care Manual page 30

Operatin User Interface Features
Se ing Preferences, continued
INSTALL CYCLE
Run the INSTALL CYCLE before operating the wash-
er the first time. Remove all items from the washer
drum and press start. For more information on
performing the washer INSTALL CYCLE, refer to the
Installation Instructions accompanying this washer.
If the washer has been installed according to
Installation Instructions, JTISTRLL PRSSEB - DOOR
CRT1BE OPETIED will be displayed and the washer
is ready to use.
If the washer was not installed properly, nO WATER -
OPET} WATER URLUES, WATER HOSES- CHECH
WRTER HOSES or CALL SERUEE 877 HBS B287
will be displayed to indicate the installation error.
The errors may result from the following conditions:
• nO UJRTER --Water inlet hoses have not been at-
tached to water supply or water supply valves have
not been turned on. Install hoses correctly and turn
on water supply valves.
- CHECN HOSES --The hot inlet hose may have
been connected to the cold water supply and the
cold inlet hose may have been connected to the
hot water supply. Check hoses for correct sup-
ply connection. If incorrect, disconnect hoses and
connect to correct inlets according to Installation
Instructions.
- CALL SERUICE 87"7 HBS B2BT--Error can only
be corrected by calling a qualified technician (1-
877-435-3287).
Repeat the INSTALL CYCLE when corrections are
completed.
RESET
Press the buttons indicated to restore only cycle set-
tings, reset only factory preferences (users, language,
brightness, volume, etc.) or restore all factory defaults
(both cycle settings and factory preferences). Press
the button under EXiT to return to normal operation
or press the cancel button to turn the washer off
without making any changes. If you do not make a
selection within 30 seconds the washer will return to
normal operation without any changes, tf you reset
all settings, INSTALL CYCLE will be displayed as
though the washer were just turned on for the first
time. You may press the button under CANCEL if you
do not wish to rerun the INSTALL CYCLE.
NOTE
The INSTALL CYCLE is prompted automatically
only once when the washer is turned on the
first time at the end of installation. After that,
if you wish to run a subsequent INSTALL
CYCLE when moving the washer or modifying
your installation, you may perform your own
INSTALL CYCLE by selecting it in the set prefs
feature and then following the screen prompts.
m
JMSTALL CYCLE i
sel_
s¢l_