Kenmore 41797962702 Use And Care Manual page 6

27" (69 cm) wide laundry center washer - dryer
Table of Contents

Advertisement

Do notload i tems above
topofagitator vanes inwash t ub.
Built-In Fabric Softener Dispenser
(some models)
Built-In Fabric Softener
Dispenser
(some models)
DO NOT REMOVE
SERVICE CAP
INSIDE
THE AGITATOR
POST.
Safety
Lid
Lock
Washing
Procedures
con't
6. Add
laundry
load to washer.
Dry load level should not be higher than the top of agitator
vanes.
Do not overload
the washer.
Do not put items on top of agitator or wrap them around it. Load items
evenly.
Combine
large and small items in a load. Load large items first.
Large
items should not be more than half the total wash load.
When washing
a single heavy item, add 1 or 2 towels to balance the
load.
7.
If desired,
add liquid
fabric
softener
to Fabric Softener
Dispenser
(available
on some models).
For models
with
a built-in
dispenser
(see picture
to the left):
1.
Add liquid softener
to the dispenser,
following
fabric softener
label
directions.
2.
Add water to bring liquid level to fill line on dispenser cap.
3.
Remove the dispenser from the agitator
after each use. Rinse both
cap and cup with warm water.
Replace dispenser in the agitator.
NOTE: To separate cap from
cup, put thumb
into dispenser and push
against side of cup (see picture to the left). After cleaning, push cap and
cup firmly together.
Replace dispenser by lining up the ribs and grooves
and snapping
it into position.
If fabric softener
builds up in or around the
dispenser,
clean the area with hot water.
DO NOT
REMOVE
SERVICE
CAP FOUND
INSIDE
THE AGITATOR
POST.
8.
For models
without
a fabric softener
dispenser,
follow fabric softener
label directions. Add diluted fabric softener to the final rinse. Do notpour
fabric
softener
directly
on the wash
load.
Select
cycle and settings
according
to type,
size, and soil level
of
each load
See Operating
Instructions
for your specific model controls.
1
Start
the washer.
Close the washer lid and pull out the cycle selector knob. The washer will
not agitate or spin with the lid open.
*
To stop the washer,
push in the cycle selector knob.
*
To change a cycle, push in the cycle selector knob. Turn it clockwise
to the desired setting.
Pull out the knob to restart the washer.
10. Remove
items
when
the cycle is completed.
For your safety, the lid locks when the tub is spinning.
It will remain locked
for 2-3 minutes after the tub stops spinning.
To open the lid during a spin, push in the cycle selector knob and wait
about 2-3 minutes for the lid lock to release. Do not force open the
locked lid.
Place washed items in automatic
dryer, line dry, or dry flat as directed by
fabric care label. Excess wrinkling,
color transfer or odors may develop in
items left in the washer after the cycle has ended.
To avoid serious personal injury, do not operate washer if safety
lid lock is missing or damaged.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

41797912701417978227014179797270141797922701

Table of Contents