Free Arm Sewing; Accessory Storage Box; Change The Presser Foot; Choose Your - Kenmore 3851278191 Owner's Manual

SECTION 2. PREPARE YOUR MACHINE FOR SEWING
Set Up the Machine (Continued)
• Free-Arm Sewing: the Removable
Extension Table
To Remove the Extension Table
(for free-arm sewing)
• Accessory Storage Box • Change the Presser Foot
The lid of the accessory storage Use the correct presser foot for
box lifts open toward you. the stitch you wish to sew.
1. Grip the table with your index finger Sewing accessories are conveni-
To change the various presser
and thumb, as shown, ently located in the box. :_t, raise the presser bar to its
2. Puttgently to theleft. The_e_ ...........
table Will snap outl
To Attach the Extension Table
(for flat-bed sewing)
1. Insert the tab and the pin into their
catches.
2. With your thumb and index finger,
gently snap in.
Choose Your Needle and Thread
• To Change Your Needle
Flat
side
away
from
you
Ne_'_e clamp screw \
NOTE: Raise the needle bar to its highest
position by turning the hand wheel
toward you.
........................ hi_est posi{t6n b¥li_Jng the .... 1. Loosen the needle clamp===_ew by
presser foot lever.
Loosen the presser foot thumb
screw, choose the proper foot,
insert from the bottom.
Tighten the screw using the
large screw driver to make
certain the foot is secure.
turning it toward you.
2. Remove the needle by pulling it down-
ward.
3. Insert the new needle into the needle
clamp with the flat side away from you.
4. Push the needle up as far as it will go.
5. Tighten the needle clamp screw firmly
with the large screwdriver from your
accessory box.