Preset Memory; Operating A Component Stored In The Preset Memory - Denon AVR-686 Operating Instructions Manual

Advanced Operation Advanced Operation
• DENON and other makes of components can be operated by
setting _ne oreseT memop.
• This emote CORer unl_ can De usea _o operate comDonems of
other manuTac_urers ^/ltnou_ using _ne learning function D
registering _ne Tlanufacturer of the comoonent as ShOWn in me
3t ot orese_ come. < _ End of this manua
• ODeraiion E not L_OSSlble for some moaels,
1
Set the MODE 1 switch to "AUDIO" or "VIDEO".
AUDOq
.VD[O
÷ Set TO The AUDIO side for the C0 TAPE or CDRiMD boston.
an(] to the VIDEO side for the DVD/VDF DBS/CABLE CR
or TV POSITIOn
_et the
MODE 2
switch to the component to be
registered.
CDR/MD_ _TAPE
C0_ _ZONE2
DVDIVDP_ _TV
VCR DBS CABLE
Press the
ON/SOURCE
a nd
OFF
button at the
same time.
• The indicator starts flashin j.
4
Referring to the included list of preset codes.
press the
NUMBER
buttons to input the preset
code (a 3-digit number) for the manufacturer of
the component whose signals you want to store
in the memory:
To store the codes of another component in the
memory, repeat steps 1 to 4.
• The signals for the pressed buttons are emitted while setting
the preset memory. To avoid accidental operation, cover the
remote control unit's transmitting window while setting the
preset memory.
• Depending on the model and year of manufacture, this function
cannot be used for some models, even if they are of makes
listed in the list of preset codes.
• Some manufacturers use more than one type of remote control
code. Refer to the included list of preset codes to change the
number and verify correct operation.
• The preset memory can be set for one component only among
the following: CDR/MD, DVD/VDP and DBS/CABLE.
• The preset codes are as follows upon shipment from the
factory and after resetting:
• TV, VCR ......................................... HITACHI
• CD, TAPE ....................................... DENON
• CDR/MD ........................................ DENON (CDR)
• DVD/VDP ....................................... DENON (DVD)
• DBS/CABLE ................................... ABC (CABLE)
I Set the MODE 1 switch to "AUDIO,, or ',VIDEO,':
'_ Set to the AUDIO side for the CD TAPE or CDR/MD position
and to the VIDEO side for the DVD/VDP, DBS/CABLE, VCR
3
÷ For details, refer to the component's operating instructions:
÷ Some models cannot be operated with this remote control
unit.
32
L ENGLISH J