Assembly - Husqvarna 1365GN Owner's Manual

Assembly
2. Slide axle through both axle mounting brackets on
cradle frame, as shown in Figure I.
3. Slide a wheel over the axle.
BEFORE STARTING THE
ENGINE
NOTE: Be sure to install both wheels with the air
pressure valve on the outboard side.
4. Placethe e-ring onto the groove in the axle.You may
add the fiat washer if desired.
NOTE: Use retaining pins insteadof e-clip, if applicable.
Add Engine Oil and Fuel
• Placegenerator on a level surface.
• Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
CAUTION
5. Place one end of the needle nose pliers on the bottom
of the axle and the other end of the pliers on top of
the e-ring. Seat the e-ring by pressing the pliers closed.
6. Repeat step 3 through 5 to secure second wheel.
7. Remove the temporary blocks.
8. Attach the vibration mounts to the support leg with
3/4" capscrews and lock nuts.
9. To aid support leg assembly,rest generator on cradle,
engine end down. Remove the existing hardware from
the left unit vibration mount with 13mm wrench. Use
the same hardware to attach the support leg.
10. Attach the other side of the support leg with a 20 mm
cap screw and lock nut. Rest generator on wheels and
support leg.
• Refer to engine manualfor oil andfuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
NOTE: Check oil often during engine break-in. Refer to
engine owner's manual for recommendations.
NOTE:The generator assembly rotates on a pretubricated
and sealed bait bearing that requires no additional
lubricationfor the life of the bearing.
I I. Attach handlesto handle brackets on generator frame,
as shown in Figure I,with 45 mm capscrews, flat
washers, nylon washers, and lock nuts.
12. Loop handle pins to generator frame as shown in
Figure I. Raise handles and insert handle pins to move
generator.
13. Check eachfastener to ensure it is secure and the
tires are inflated between 15-40 PSI.