Assembly - Husqvarna 1365GN Owner's Manual

Assembly
ASSEMBLY
Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-877-224-0458.
Remove Generator From Carton
I. Set carton on a rigid fiat surface with "This Side Up"
arrows pointing upward.
2. Carefully open top flaps of shipping carton.
3. Cut down corners at one end of carton from top to
bottom and laythat side of carton down fiat
4. Remove all packing material, carton fillers, etc.
5. Remove generator from shipping carton.
Carton Contents
Check all contents. If any parts are missing or damaged,call
the generator helpline at 1-877-224-0458.
The generator
Generator and engine owner's manuals
Locking 30 Amp plug
Battery charge cables
Engine oil
Wheel kit
Install Wheel Kit
The wheel kit is designedto greatly improve the portability
of your generator.
NOTE: Wheel kit is not intendedfor over-the-road use.
You will need a socket wrench with I/2" or 13mm sockets
and a needle-nose pliers to install this kit.
Refer to Figure I and install the wheel kit as follows:
I. Placethe bottom of the generator frame on a fiat, even
surface.Temporarily place unit on blocks to ease
assembly.
Handle Pin
Nylon Washer
45 mm Ca
Flat Washer
Handle
Use existing hardware
to attach left side of
support leg to unit
Nut
Vibration Mount
Wheel
Flat Washer
Axle
20 mm Cap Screw
/
E-Ring
3/4" Cap Screw Nut