Table of Contents
Advertisement
CLEANING
TIPS (cont.)
PART
Chrome drip bowls
Brown food stains
CLEANING
MATERIALS
Blue/gold heat
stains
Detergent and water, plastic scouring
pads, mild abrasive cleaners, soap-
filled scouring pads, ammonia
Met_ P_Lsh
REMARKS
Bowls
can permanently
discolor
if
exposed
to excessive
heat or if soil
is allowed
to bake
on.
After each use, wash, rinse and dry to
prevent difficult soils.
If heavily soiled,
place an ammonia-soaked
paper towel on
stains to loosen soil, than gently scrub
with plastic scouring pad.
These stains are caused by overhaatlno,
nonnally occur over a period of tin_ and
usually am permanent. To mln_ntze:
1. AvOid excessive use of the high heat
setting. Use Itto sfart cooklng,t hen lower
the heat setting to finish cooldng.
2. Use flat bottom pans that do not exterKI
more than two Inches from the surface
e_rnenL
REMOVABLE
KNOBS
The control knobs may be removed for easy cleaning by
pulling the knob strslg ht off stem. Be sure that the knob
is In the OFF position before removal.
Hint: Slip a thin cloth (such as a handkerchief) or a piece
of string under and around the knob edge and pull up.
Caution:
Read
these
instructions
carefully
be-
fore replacing
the knobs.
Replacing
the knobs
improperly
will damage
the knobs and the spring
clip on the stems.
If this happens,
the knobs will
fit loosely.
To replace
the knob:
1. The knob stem has a groove In each side. The groove
on one side has a spring clip. The other groove Is
clear (sea Illustration).
2. Check the Inside of the knob and find the molded rib.
3. Replace the knob by fitting the molded rib Inside the
knob Into the clear groove on the stem.
MOLDED
RIB
SPRING
CLIP
REMOVABLE
COOKTOP
UNITS
The cooktop elements can be unplugged and the bowls
removed for cleaning.
Be sure all cooktop
unit control
knobs are turned
off and elements
are cool before
you remove
or
replace
a cooktop
unit.
To remove=
1. Grasp element,
tilt It upward slightly to clear the
bowl, t hen pu II away from t he receptacle. The element
will not sit level when replaced If It Is forced too far
upward when removed.
2. See the Cleaning Tips Section about Information on
cleaning reflector bowls.
3. Lift out the bowl.
Do not put the element Into water. It cleans Itself when
heated during normal use.
IMPORTANT:
Never
operate
a cooktop
elelnent
without
the
bowl
in place.
This
can
cause
scorching
of the cooktop,
burning
of wiring
insu-
lation
and loss of energy.
To replace:
1. Replace the bowl. Be sure the receptacle Is showing
In the bowl opanlng.
2. Slide the plug of the element firmly Into tha receptacle
and lower the element Into place.
10
NECCH34
Advertisement
Table of Contents
