Kenmore 9802 - Elite 30 in. Electric Range Installation Instructions Manual

iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED TECHNiCiAN.
iMPORTANT: SAVE FOR THE LOCAL ELECTRICAL iNSPECTOR'S USE.
READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE.
1. Clearances and Dimensions
a. Provide adequate clearances between the range and adjacent combustible surfaces.
b. Location--Check location where the range will be installed. Check for proper electrical supply and the stability of floor.
c. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must
be solid and level.
FRONT TYPICAL CABINET iNSTALLATiON
ViEW
Minimumto 1"
wail on either - Pit
side of range I
I
above 36" height. I
° s"#vff
1_13"÷
18" cabinets on Maximumdepth
"" either side for cabinets f/
_------- 3 01/8 "--------_ O"dearance below cooking top and at rear of range.
1' 30" --_ I
30"
Minimum t
Minimumto
FRONT
VIEW
T
49" l
Maximum
36 ± 1/8"
46' X
\..
Door open
"\ 30,,.11"v_-_
29-7/8"--._i I 25-3/4"
* 30" minimum clearance between the top of the cooking surface
and the bottom of an unprotected wood or metal cabinet; or 24 "
minimum when bottom of wood or metal cabinet is protected by not
less than 1A"flame retardant millboard covered with not less than
no. 28 MSG sheet steel, 0.015" stainless steel, 0.024" aluminum or
0.020" copper. The minimum clearance is O"for the rear of the
range. Follow all dimension requirements provided above to
prevent property damage, potential fire hazard, and incorrect
countertop and cabinet cuts.
Avoid locating cabinet storage space above the surface units to
eliminate the possibility of cabinets catching on fire, or
personal burns from reaching for the cabinets over the heated
units. If cabinet storage is to be provided, risk can be reduced
by installing a range hood that projects horizontally a minimum
of 5" beyond the bottom of the cabinets.
Important Notes to the Installer
1. Read all instructions contained in these installation instructions
before installing the appliance.
2. Remove all packing material before connecting the electrical
supply to the appliance.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consumer.
important Note to the Consumer
Keep these instructions with your Use and Care Guide for future reference.
Printed in United States
BACK
ViEW
_f '-:i:- ...........__ -_--__o_ electrical outlet
',//_ _- ........ location are maximum.
• / ........................ ( Cubed area shows '
I / Terminal'_ I where the electricall I
I Block [ _/ outlet must be
I Location .__ installed for the
',/ ' "_ :'_-_'1range to be flush
I'_- 9' _ _ ,, to
the wall. /;
o ,o,I t
"_" _ 3"_ -_:-__v _
Edge
318201720 (0807) Rev. A