Features; Using The Air Conditioner - Kenmore 580.74109 Owner's Manual

FEATURES
1 16 13 5 4 3 2 7 6
8 14
12 10 11 15
FIG. 13
HORIZONTAL AIR DIRECTION CONTROL
The horizontalair direction is adjustedby moving the vertical
louvers lever right and leftwith your fingertips. (FIG. 14)
USING THE AIR CONDITIONER
V.'_ViVl.'1;]_ll#[_!
To reduce the risk of fire, electric
shock, or injury to persons, read the important
SAFETY instructions section before operating this
appliance
To begin operating the air conditioner after
installation, follow these steps:
(The air discharge grille is closed when the air
conditioner is off)
1. Plug in the air conditioner. (To prevent electrical
hazards, do not use an extension cord or an
adapter plug.)
2. Set the TEMP Control to the coolest setting.
3. Set the MODE Control at the highest COOL level.
4. Adjust the louvers for comfortable air flow.
5. Once the room has cooled, adjust the TEMP and
MODE Control to the setting you find most
comfortable.
NOTE : If the air conditioner is turned off, wait 3
minutes before restarting. This allows pressure
inside the compressor to equalize. Failure to wait 3
minutes before restarting may cause inefficient
operation.
If you move the TEMP Control to a warmer, then
immediately back to a cooler setting, the unit will
shut off. Wait 3 minutes before restarting.
1. Cabinet 8. Power Cord
2. Vertical Air 9. Evaporator
Direction Louvers 10. Condenser
3. Horizontal Air 11. Compressor
Direction Louvers 12. Base pan
4. Front Panel 13. Curtain
5. Air Filter(Inside) 14. Control Box
6. Front Grille 15. Remote Control
7. Control Board 16. Hand Grip
VERTICAL AIR DIRECTION CONTROL
The verticat air directionis adjustedby moving the horizontal
louvers up and down with your fingertips. (FIG. t5)
FIG. 14 FIG. 15
-10-