Cleaning The Carpet - Kenmore 175.8579280 Owner's Manual

OP
TEST FOR SOLUTION SPRAY
See Figure 6
1. Hold Floor Nozzle above floor level.
2. Pull Solution Release Trigger on Angled Wand.
3. Obsewe Floor Nozzle to make sure cleaning solution
is being sprayed evenly from two points. (see
DETAIL "A" )
NOTE: If solution is not being sprayed from both points,
refer to Trouble Shooting Chart.
CLEANING THE CARPET
See Figures 7 & 8
Solution Dispensing Stroke:
1. Start at a corner (recommended).
2. Place Floor Nozzle so Suction Inlets are flush with
carpet.
3. While exerting light pressure down on Floor Nozzle,
depress Solution Release trigger and slowly pull
Floor Nozzle towards you.
NOTE: Do not ovenNet. If three or more cleaning strokes
are required, let dry and then repeat cleaning proc-
ess.
Solution Recovery Stroke:
1. Release Solution Release Trigger.
2. Lift Floor Nozzle off carpet.
3. Return Floor Nozzle to point where you dispensed
cleaning solution and pull across carpet, recovering
dirty solution.
RATIO
RELEASE
TRIGGER
/
DETAIL
_PRAYS OF
SOLUTION
Fig. 6
SLOWLY PULL
TOWARDS YOU
SUCTION INLETS
Fig. 7
LIFT,
SET FORWARD,
PULL BACK ACROSS CARPET
I
Fig. 8
Page 6