Kenmore 93788 Owner's Manual page 25

Cam and Cleaning
(continued)
PKug-lnSurface Units
Clean the area under the drip pans often.. Built-up soil,
especially grease, may catch fire.
Caution: Be sure all controls are turned to OFF and
surface units are cool before attempting to remove
them.
To make cleaning easier,
the plug-in surface units
are removable°
Lift a plug-in unit about 1"
above the drip pan--just
enough to grasp it--and
you can pull it out.
Do not lift a plug-in unit
more than 1" If you do, it
may not lie flat on the
drip pan when you plug
it back in.
Repeated lifting of the plug-in unit more than 1"
above the drip pan can permanently damage the
receptacle.
After removing a plug-in unit, remove the drip pan
under the unit and clean it according to directions in
the Cleaning Guide on page 27, Wipe around the edges
of the surface unit opening, Clean the area below the
unit. Rinse all washed areas with a damp cloth or
sponge°
Toreplace a plug-in unit:
o Place the drip pan into
the surface unit cavity
found on top of the cook-
top so the unit receptacle
can be seen through the
opening in the pan.
Receptacle
Drip Pan
o Insert the terminals of the plug-in unit through the
opening in the drip pan and into the receptacle.
o Guide the surface unit into place so it fits evenly into
the drip pan.
CAUTION
o Do not attempt to clean plug-in surface units in an
automatic dishwasher.
o Do not immerse plug-in surface units in liquids
of any kind.
a Do not bend the plug-in surface unit plug terminals°
Do not attempt to clean, adjust or in any way repair
the plug-in receptacle.
Adjusting Oven Thermostat
Use time given on recipe when cooking first time. Oven
thermostats, in time, may "drift" from the factory setting
and differences in timing between an old and a new
oven of 5 to 10 minutes are not unusual° Your oven has
been set correctly at the factory and is more apt to be
accurate than the oven which it replaced. However, if
you find that your foods consistently brown too little or
too much, you may make a simple adjustment in the
thermostat (OVEN CONTROL) knob.
PULL KNOB OFF OF SHAFT, LOOK AT BACK OF
KNOB AND NOTE CURRENT SETTING BEFORE
MAKING ANY ADJUSTMENT.
To increase temperature, turn toward HI or RAISE; to
decrease, turn toward LO or LOWER. Each notch
changes temperature 10 degree&
To adjust oven thermostat for either oven:
1. Pull off OVEN CON-
TROL knob for oven need-
ing adjustment,, Loosen
both screws on back of
knob.
2. Move pointer one notch
in desired direction.
Tighten screw&
3. Return knob to range, matching flat area of knob to
shafL
Recheck oven performance before making an addi-
tional adjustment°
26