Kenmore 93788 Owner's Manual page 22

Operating the SeSf=Cteaning Oven
Before Setting Oven Controls,
Check These Things:
Step 1:
Remove broiler pan, broiler rack and other cookware
from the oven. (Oven shelves may be left in oven. Note:
Shelves will discolor after the self-clean cycle,,
Step 2:
Wipe up heavy soil on oven bottom.
A. Oven Front Frame
B. Oven Door Gasket
C. Openings in Door
D. Oven Light
Step 3:
Clean spatters or spills on oven front frame (A) and oven
door outside gasket (B) with a dampened cloth. Polish
with a dry cloth., Do not clean gasket (B),, Do not allow
water to run down through openings in top of door (C)_
Never use a commercial oven cleaner in or around self-
cleaning oven°
Step 4:
Close oven door and make sure oven light (D) is off.,
How to Set Oven for Cleaning
Step 1:
Turn OVEN SELECTOR
and OVEN CONTROL
knobs to CLEAN. Con-
trols will snap into final
position when the CLEAN
location is reached.
Step 2:
Slide the LATCH HANDLE
to the right as far as it
will go,,
Step 3:
Set the automatic oven
timer:
o Make sure both the range clock and the START dial
show the correct time of day. When the START knob
is pushed in and turned, it will "pop" into place when
the time shown on the range clock is reached,
Q Decide on cleaning hours necessary.
Recommended Cleaning Time:
Moderate Soil--2 hours (thin spills and light spatter)
Heavy Soil--3 hours (hearty, greasy spills and spatter)
o Add these hours to present time of day, then push in
and turn STOP dial clockwise to this desired stop time.,
OVEN CLEANING light glows, showing cleaning is
starting,
The OVEN LOCKED light will glow, indicating oven is
hot and door cannot be opened° Oven door and window
get hot during self-cleaning, DO NOT TOUCH.
I (continued newt page_
23