Amana NTW4750YQ1 Use And Care Manual page 9

WASH TEMPERATURE
all cold rinses
cool
lights
cool
darks warm
cold hot
Once you select a cycle, select the desired wash temperature
by turning the Wash Temperature knob to the desired setting.
NOTE: Always read and follow fabric care label instructions to
avoid damage to your garments.
Wash Temp
Hot
Some cold water is added to save
energy. This will be cooler than
your hot water heater setting.
Warm
Some cold water will be added, so
this will be cooler than what your
previous washer provided.
Cool Lights
Warm water is added to assist in
soil removal and to help dissolve
detergents.
Cool Darks
Warm water may be added to
assist in soil removal and to help
dissolve detergents.
Cold
This is the temperature from your
faucet. If your tap cold water is
very cold, warm water may be
added to assist in soil removal and
help dissolve detergent.
Suggested Fabrics
Whites and pastels
Durable garments
Heavy soils
Bright colors
Moderate to light soils
Colors that bleed
or fade
Light soils
Colors that bleed
or fade
Light soils
Dark colors that
bleed or fade
Light soils
O, Select cycle options, if desired
OPTIONS STAIN TREAT
extra fabric
rinse softener off
fabric
softener
If you would like to add an Extra Rinse, Fabric Softener,
Fabric Softener with Extra Rinse and/or use the Stain Treat
option, turn the knob for that feature.
9, Press START/Pause/Unlock Lid
to begin wash cycle
START
PAUSE/
UNLOCK UD
©
CANCEL .OLD3sEc
Press the START/Pause/Unlock Lid button to start the wash
cycle. Filling is delayed for several minutes while load balance
is sensed. When the cycle has finished, the Cycle Complete
indicator will light. Promptly remove garments after cycle has
completed to avoid odor, reduce wrinkling, and rusting of
metal hooks, zippers, and snaps.
Unlocking the lid to add garments:
If you need to open the lid to add 1 or 2 missed garments:
Press START/Pause/Unlock Lid; the lid will unlock once
the washer movement has stopped. This may take several
minutes if the load was spinning at high speed. Then close lid
and press START/Pause/Unlock Lid again to restart the cycle.
If lid is left open for more than 10 minutes the water will pump
out automatically.
Delay in water fill
Filling is delayed for 2 to 3 minutes to check for load
unbalance. You will hear the hum of the spin prior to filling.
This is normal operation.