JVC GR-DV3 Instructions Manual page 21

iiiiiiiiiiiiliii ii ii ii ii il iii!iiiililililililililililililililililililil EN¸2 ]
TimeCode
During recording, a time code is recorded on tile tape. This code is to cr)nfirm tile location of tile
recrlrded scene on the tape during playbacl<.
If recording starts from a blank portion, the time code begins crlunting from "00:00:00"
(minute:second:frame). If recording starts from the end rlf a previously recorded scene, the time code
continues from the last time code number.
To perform Random Assemble Editing (_-T_ pg. 61), time crlde is necessary. If during recording a blanl<
portion is recorded partway through the tape, the time code is interrupted. When recording is resumed,
the time code starts counting up again from "00:00:00". This means the camcorder may record the same
time crldes as those existing in a previously recorded scene. To prevent leaving a blanl< portion on a
tape, perform the prr)cedure in "Recording From The Middle of A Tape" (_ / pg. 20) in the following
cases;
• After playing back the recorded tape, when
you shoot again.
°When power shuts off during shooting.
°When a tape is removed and re-inserted
during shooting.
°When shooting using a partially recorded tape.
°When shooting tin a blank portion located
partway through the tape.
°When shooting again after already shooting a
scene and opening/clr_sing the cassette cover.
Display
Time code is displayed
during playbat-k,
(25 frames = I second)
NOTES:
• The Time (_c]_ carlrlot be r_set.
• Durirlg l[lst-lbrwarding arid rewirlding, time c_;rld irldicatiorl does riot move smoothl_<
When blank portion is recorded on a tape
Thlle code Time _-ode Thne code
00:00:00 05:43:21 00:00:00
Tape
Shooting start point Shooting stop point Shooting start point
Proper recording
Time code Time _-ode Thole code
00100100 05143121 05144100
Tape
Shooting start point Shooting start point Shooting start point