Set Lock Code - JVC AV-27WR25 User Manual

Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes
pre-set with a lock code of "0000". You may change the code to any four-digit number you wish.
To change the lock code, follow the steps below.
(_ Press the MENU button
a.V To SET LOCK CODE
• • To operate (lock icon I_ appears)
(_ Press ZEROto access the lock code
The first digit will be highlighted
• • To select the number
,_, INETIAL SETUP> a'_
SET LOCK CQDE
0000
SELECT BYe#
OPERATE BY_ EXiT BY[_I
AV To move to the next digit
Continue to follow these directions for all four numbers
AV
To FINISH
To save settings and exit
(your lock code is now set)
Press the EXIT button when finished
When a viewer attempts to watch a blocked channel, this message appears:
TH s ROGRAMM Na EXCEEDS
YOUR RATING LIMIT& I
PLEASE ENTER LOCK CODE By I
! 0 KEY pAD T0 UNLOCK IT:
1
The channel will remain blocked until the correct lock code is entered (see above for inbrmation
on setting your lock code).
Notes:
• After a power interruption you must reset the lock code.
• Write your lock code number down and keep it hidden from potential viewers.
• If you forget the lock code, a new code may be set using the steps listed above.
m