Table of Contents
Advertisement
Grip Adjustment
1) Separate
the Velcro strip.
2) Pass your right hand through the loop and grasp
the grip.
3) Adjust so that your thumb and fingers
can easily
operate
the Recording
Start/Stop
Button O and
Power Zoom Lever O. Refasten
the Velcro strip.
O
O
__
Velcro
Strip
Tripod Mounting
Align the screw and camera direction
stud on the
tripod with the tripod mounting
socket _). Then
tighten the screw.
When using a tripod,
be
sure to open and extend
its legs fully to stabilize
the camcorder.
To
prevent
damage
to the
unit caused
by falling
over, do not use a
small-sized
tripod.
Viewfinder
Adjustment
1) Set the Power Switch _) to "n"
or "[_" while
pressing
down the Lock Button _) located
on the
switch.
2) Turn the Diopter Adjustment
Control _I until the
indications
in the viewfinder
are clearly focused.
@
Shoulder
Strap
Attachment
Thread the strap through
the eyelet _), then fold it
back and thread it through the buckle. Repeat the
procedure
to attach the other end of the strap to
the other eyelet 1_), making
sure the strap is not
twisted. Adjust
the length.
Loading/Unloading
A Cassette
1) Open the LCD monitor fully and keep it aligned
vertically
with the camera
(do not tilt it at an
angle). Slide EJECT (D until the cassette
holder
opens. Do not use force to open.
2) Insert or remove a cassette.
When inserting,
make sure the label is facing outward,
r_
appears
when a cassette
is loaded.
3} Press the Close button _) to close the cassette
holder until it locks into place. Close the LCD
monitor.
• Closing
the LCD monitor while the cassette
holder
is still open may cause damage
to the LCD
monitor.
• Make sure the erase protection
tab is in the
position that allows recording.
If not, slide the tab.
Some cassettes
have removable
tabs. If the tab
has been removed,
cover the hole with adhesive
tape.
• The cassette
holder cannot be opened while the
camcorder
is in the record mode or detached
from
the power source.
Cassette
holder
Advertisement
Table of Contents
