Frigidaire FGGF301DNBB Use & Care Manual page 23

REHOVING AND REPLACING THE LIFT-
OFF OVEN DOORS
The door is heavy. For safe, temporary storage, lay the
with the inside of the door facing down.
Most oven doors contain glass that can break.
Read the following recommendations:
1. Do not close the oven door until all the oven racks
are fully in place.
2. Do not hit the glass with pots, pans, or any other
object.
3. Scratching, hitting, jarring or stressing the glass may
weaken its structure causing an increased risk of
breakage at a later time.
To Remove Oven Door:
1. Open oven door completely (horizontal with floor - See
Figure 1).
=
Door Hinge locations
with oven door fully open
Figure 1
Pull the door hinge locks on both left and right door
hinges down from the oven frame completely towards
the oven door (See Figure 2). A tool such as a small
fiat-blade screwdriver may be required.
Figure 2
=
==
=
Firmlygrasp both sides of oven door along the door sides
(Do not use the oven door handle - See Figure 3).
/ /
&round
Hinge
Figure 3
Close the door to the broil stop position (the oven door
will stop into this position just before fully closing).
With the oven door in the broil stop position, lift the
oven door hinge arms over the roller pins located on
each side of the oven frame (See Figure 4).
Roller pin
Hinge arm hook
Hinge arm notch
Slot bottom
Figure 4
To Replace Oven Door:
1. Firmly grasp both sides of oven door along the door sides
(Do not use the oven door handle - See Figure 3).
2. Holding the oven door at the same angle as the removal
position, seat the hook of the hinge arm over the roller
pins located on each side of the oven door frame (See
Figure 4). The hook of the hinge arms must be fully
seated onto the roller pins.
3. Fully open the oven door (horizontal with floor - See
Figure 1).
4. Push the door hinge locks up towards and into the oven
frame on both left and right oven door hinges (See
Figure 2) to the locked position.
5. Close the oven door.