INSTALLATION
AND SERVICE
MUST
BE PERFORMED
BY A QUALIFIED
INSTALLER.
IMPORTANT:
SAVE FOR LOCAL ELECTRICAL
INSPECTOR'S
USE.
READ AND SAVE THESE
INSTRUCTIONS
FOR FUTURE
REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable
vapors
and liquids in the vicinity of this or any other appliance.
If the information in this manual is not followed
exactly, a fire or explosion may result causing property damage,
personal injury or death.
FOR YOUR SAFETY:
=
Do not store or use gasoline or other flammable
vapors and
liquids in the vicinity of this or any other appliance.
=
WHAT TO DO IF YOU SMELL GAS:
=
Do not try to light any appliance.
=
Do not touch
any electrical
switch; do not use any phone in
your building.
=
Immediately
cail your gas supplier from a neighbor's
phone.
Follow the gas supplier's
instructions.
=
If you cannot reach your gas supplier, call the fire department.
--
Installation
and service must be performed
by a qualified
installer, service agency or the gas supplier.
• All appliances can tip.
• Injury to persons
could result.
® Install anti=tip
bracket p_cked with
your appliance.
• See Installation
Instructions.
Note: For appliance installed in the
State of Massachusetts see page 2.
Front
view
49"
Maximum
A_
36 -+ 1/8"
/
,\
* 30" minimum clearance between the top of the cooking surface and the bottom of an unprotected
wood or metal
cabinet; or 24" minimum when bottom of wood or metal cabinet is protected by not less than 1/4" flame retardant
millboard covered with not less than no. 28 NSG sheet steel, 0.015" stainless steel, 0.024" aluminum or 0.020" copper.
The minimum clearance is 0" for the rear of the range. Follow all dimension requirements provided above to prevent
properly damage, potential fire hazard, and incorrect countertop and cabinet cuts.
Avoid locating
cabinet
storage
space above
the
surface
burners.
The absence
of cabinets
will
eliminate
the chance of cabinets
catching
on fire,
and eliminate
the possibility
of receiving
personal
burns from reaching for the cabinets over flaming
surface burners. If cabinet storage is to be provided,
risk can be reduced by installing a range hood that
projects
horizontally
a minimum
of 5" beyond the
bottom of the cabinets.
Provide proper fuel type
Before
proceeding"
Your range
is factory
preset
to
operate
on natural
gas. If LP. conversion
is needed,
contact your local LP. Gas provider forassistance.
Contact your product dealer to obtain the correct LID.
conversion kit.
Printed in Canada
318201793 (1208) Rev. C