Jenn-Air JSD2695KGB Use & Care Manual page 7

I NSTALLATI O N
Connecting the Water Supply
(select models)
Notes:
• Use copper tubing only for installation. Plastic is
less durable and can cause damage.
• Add 8' to tubing length needed to reach water
supply for creation of service loop.
Create service loop with
copper tubing (minimum 2'
diamete0. Avoid kinks in the
copper tubing when bending
the service loop. Do not use
plastic tubing.
2' diameter
minimum
2. Remove plastic cap from water valve
inlet port.
3. Place brass nut (A) and sleeve (B)
on copper tube end as illustrated.
Reminder: Do not use an old
sleeve. The nut and sleeve are
provided in the Use and Care
packet.
.
Place end of copper tubing into
water valve inlet port. Shape
tubing slightly - Do not kink - so
that tubing feeds straight into inlet
port.
Materials Needed
• '/4"outer diameter flexible copper tubing
• Shut-off valve (requires a '/4" hole to be drilled into
water supply line before valve attachment)
• Adjustable wrench (2)
• '//' hex nut driver
5. Slide brass nut over sleeve and
screw nut into inlet port.
Place adjustable wrench on nut
(1) attached to plastic waterline
and maintain position.
Using second adjustable wrench
turn the lower nut (2)
counterclockwise an d fully
tighten while holding the upper
nut in place.
Important: Do not over-tighten. Cross threading
may occur.
Cont.