Installation - Jenn-Air JSD2695KGB Use & Care Manual

I NSTALLATI O N
Door and Hinge Removal
Some installations require door removal to get
refrigerator to final location.
Materials Needed:
• Phillips screwdriver
• %" heax head screws
1. Unplug power cord from power source.
2. Remove toe grille (see page 5).
• Open both doors 180°, or as wide as possible.
I Note:
For refrigerators in operation, shut off water
before removing water line from the door.
To Disconnect the Water Line:
• Push in white collar (A) and hold.
• Pull the door-side tube from the connector (B).
To Reconnect the Water Line:
• Firmly push tube %" into the connector. Use
lines on the tube as a guide for full insertion.
• If tube end is
damaged, cut off 5/8"
before reconnecting.
• If leaking occurs,
reconnect the line.
3. Close doors.
.
5_
6_
Remove top hinge covers by
removing Phillips screws.
Unscrew 5/,,, hex head screws from
top hinges.
For ice and water dispensing
models only: Detach main wire
connector harness.
• Do not remove screw
connecting green ground wire.
• To detach main wire harness,
use a flat blade tool or finger-
nail to press junction point
between two connectors to
release.
7. Remove top hinges along with doors.
8. Remove bottom hinges with a _" hex head driver.
Replacing the Doors
• To replace the doors, follow the steps in Door and
Hinge Removal in reverse order.
Important: If water line tube end is damaged, cut off
%" before reconnecting.