Jenn-Air JSD2695KGB Use & Care Manual page 33

TROUBLESHOOTING
Ice and Water
Freezer door is not closed.
No indicator lights
are lit on dispenser
control
Verify that freezer door is closed. Power is removed
from the control when freezer door is opened.
Plug in refrigerator.
Replace any blown fuses.
Check circuit breakers for any tripped circuits.
Call local power company listing to report outage.
See Sabbath Mode, page 18.
Refrigerator is not plugged in.
Fuse is blown, or circuit breaker needs to
be reset.
Power outage has occurred.
Refrigerator is in Sabbath Mode (select
models).
Ice or water are Freezer door is not closed. Verify that freezer door is closed. Power is removed
not dispensed from the control when freezer door is opened.
when pads are Controls are in lock mode (select models). See Dispenser LOCK page 18.
pressed Water tank is filling. At initial use, there is an approximate one- to two-
minute delay in dispensing while the internal water
tank is filling.
Ice bin not installed properly. Reinstall ice bin, see page 16.
Ice maker has just been installed or a Wait 2/4hours for ice production to begin or for ice
large amount of ice has been used. maker to restock after emptied.
Water pressure is to low. Water pressure must be between 35 to 100 pounds
per square inch to function properly.
A minimum pressure of 35 pounds per square inch is
recommended for refrigeratorswith water filters.
Water filter is clogged or needs to be Change water filter (see page 19).
changed.
Ice maker is not Ice maker has just been installed or a Wait 2/4hours for ice production to begin or for ice
producing enough large amount of ice has been used. maker to restock after emptied.
ice or ice is Water pressure is too low. Low water pressure can cause valve to leak.
malformed Water pressure must be between 35 to 100 pounds
per square inch to function properly. A minimum
pressure of 35 pounds per square inch is
recommended for refrigeratorswith water filters.
Water filter is clogged or needs to be Change water filter (see page 19).
changed.
Ice forms in inlet Water pressure is too low. Water pressure must be between 35 to 100 pounds
tube to ice maker per square inch to function properly.
A minimum pressure of 35 pounds per square inch is
recommended for refrigeratorswith water filters.
Saddle valve not open completely. Open saddle valve completely.
Freezer temperature is too high. See Temperature Contro/s, pages 9-11. Freezer
temperature should be between 0° to 2° F (-18° to
-17° C).
Refrigerator is Plastic tubing was used to complete The manufacturer recommends using copper tubing
leaking water water connection, for installation. Plastic is less durable and can cause
leakage. The manufacturer is not responsible for
property damage due to improper installation or
water connection.
Improper water valve was installed. See Connecting the Water Supply, pages 6 and Z
Self-piercing and _" saddle valves cause low water
pressure and may clog the line over time. The
manufacturer is not responsible for property
damage due to improper installation or water
connection.
Cont.
32