Jenn-Air JIM158XWRB0 Use & Care Manual page 8

6=
Reverse the door end caps as follows:
• Remove the screw and end cap from the top corner.
Move it diagonally to the opposite side's bottom corner,
keeping the straight side of the end cap facing the front of
the ice maker.
Remove the screw and end cap from the bottom corner.
Move it diagonally to the opposite side's top corner,
keeping the straight side of the end cap facing the front of
the ice maker.
A
A
A. Top Comer Open (no end cap)
B. Beginning Top Comer End Cap
C. Beginning Bottom Corner End Cap
D. Bottom Corner Open (no end cap)
7. Place the door back into the stainless skin, keeping the edge
protectors in place. Replace the two screws in the top and
bottom.
8. Set the door aside.
Reverse Hinges
1. Unscrew and remove the top hinge. Replace the screws in
the empty hinge holes.
2. Remove the screws from the bottom of the opposite side of
the ice maker cabinet. Turn the top hinge upside down so
that the hinge pin points up. Place the hinge on the bottom
opposite side of the ice maker and tighten screws.
3. Remove the plastic hinge pin sleeve from the "old" bottom
hinge and replace it on the new bottom hinge pin.
4. Remove the "old" bottom hinge screws and hinge. Replace
the screws in the empty hinge holes.
5. Remove the screws from the top of the opposite side of the
ice maker cabinet. Turn the hinge upside down so that the
hinge pin points down. Place the hinge on the top opposite
side of the ice maker and tighten the screws.
6. Remove the top hinge pin.
Replace Door
1. Place plastic hinge pin sleeve in the top hinge hole on the
door. Align the door with the top hinge hole and replace the
top hinge pin.
2. Replace the handle and handle screws (on some models).
Top Hinge
A. Hinge pin C. Hinge
B. Hinge pin sleeve
Bottom Hinge
............... A
........... B
SI::: ............ c
D. Hex-head hinge screw
"_ _ _ii_iii_:::> oA
/ & ............................. D
A. Hex-head hinge screw C. Hinge
B. Hinge pin sleeve D. Hinge pin
Reverse Door Catch
1=
2.
Remove the hole plugs from the opposite side of the door
and set aside.
Remove the screws from the magnetic door catch and
re )lace it on the opposite side of the door.
=j0 o
©
i