I NSTALLATI O N
5. Slide brass nut over sleeve and screw
nut into inlet port.
Place adjustable
wrench on nut
(1) attached
to plastic waterline
and maintain position,
Using second adjustable wrench
turn the lower nut (2)
counterclockwise
and fully
tighten while holding the upper
nut in place.
Important:
Do not over-tighten.
Cross threading
may occur.
6. Pull on tubing to confirm
connection
is secure.
Connect tubing to frame
with water tubing clamp (C)
and turn on water supply.
Check for leaks and correct
if necessary. Continue to
observe the water supply
connection
for two to three
hours prior to moving the
refrigerator
to its permanent
location,
7, Monitor water connection
for 24 hours.
Correct leaks, if necessary.