Jenn-Air JFC2089HPR Use & Care Manual page 5

I NSTALLATI 0 N
Leveling
To enhance the appearance and maintain performance,
the refrigerator should be leveled per instructions
below.
Door and Drawer Removal
Some installations require door/drawer removal to
transport the refrigerator to its final location.
Notes:
• Complete any required water supply connection
before leveling.
• Some models only have adjustment screws (A).
Materials Needed:
• %" hex head driver
• Carpenter's level.
1. Remove toe grille.
• Grasp firmly and pull outward to unclip.
2. Using hex head driver, turn the front adjustment
screws (A) on each side to raise or lower the front
of the refrigerator (see illustration below).
C C
3. Using the hex head driver, turn each of these
adjustment screws (B) to raise or lower the rear of
the refrigerator.
4. Using a carpenter's level, make sure front of
refrigerator is '/4" (6 ram) or '/2bubble higher than
back of refrigerator and that the refrigerator is level
from side to side.
5. Turn stabilizing legs (C) clockwise until firmly
against floor.
6. Turn adjustment screws (A) counterclockwise to
allow the full weight of the refrigerator to rest on
the stabilizing legs.
7. Replace the toe grille.
• Align the toe grille mounting clips with the lower
cabinet slots.
• Push the toe grille firmly until it snaps into place.
Materials Needed:
• _6" hex head driver
• Phillips screwdriver
• 3/_,, hex head driver
1. Unplug power cord from power source.
2. Remove toe grille.
3. Remove top hinge cover from
refrigerator door by removing Phillips
screw and retain screw and cover for
later use.
.
Unscrew -_,6"hex head screws from top
hinge to remove hinge and retain all
screws for later use.
Lift right side refrigerator door from
center hinge pin. Remove door
closure from center hinge pin on the
right side and retain for later use.
Disconnect wire harness on top
of left side refrigerator door top
hinge.
• Release two-pin connector by
pressing junction point with a
flat blade screwdriver or
fingernail.
• Green ground wire remains
attached to the hinge.
7. Unscrew ?6" hex head screws from [[
J<
top hinge to remove hinge and
retain for later use.
8. Remove Phillips screws to "I
remove right and left hinges and
II
retain all screws for later use.