Jenn-Air Pro Style PRG3000P Manual page 6

Sur[ace Cooking
Surface Burners
/LoF 7 ,NNERCAP\\\
PORTED BURNER RING
Your range is equipped with three part burners. The center
:aps cover the low flame settings from boilovers. These caps
also spread the flame out to avoid too much heat in pan
centel_.
The burners have a solid state ignitor. When the control knob
is turned on, gas will flow into the burner and the ignitor will
spark to light.
A properly adjusted burner with clean ports will light within
a few seconds. The flame will be blue with a clearly defined
inner cone. There should be no trace of yellow in the flame.
A yellow flame indicates an improper air/gas mixture and
should be adjusted by a service technician. (During initial
use, dust in the line or in the air may briefly cause an orange
flame.)
To Set Controls
1, Place a pan on the burner grate.
2. Push in on the control knob and turn the knob
counterclockwise to the Lite setting. A clicking sound will be
heard until the burner lights.
Control Locations
All burners have a 15,000 BTU rating on the HI setting when
using natural gas.
MODEL PRG4802P
-I T-T T-T
1 2 3 4 5 6
1. Left front surface burner.
2. Left rear surface burner.
3. Center front surface burner.
4. Center rear surface burner.
5. Right front surface burner.
6. Right rear surface burner.
MODEL PRG3610P/PRG3000P
1 2 3 4
1. Left front surface burner.
2. Left rear surface _arner.
3. Center front surface burner.
4. Center rear surface burner.