Starting And Stopping; Cold Engine; Warm Engine; Stopping - Husqvarna 125BV x-series Operator's Manual

Hide thumbs Also See for 125BV x-series:
Table of Contents

Advertisement

Available languages

Available languages

STARTING
AND STOPPING
\
• Clean the area around the fuel cap.
Contamination
in the tank can cause
operating
problems.
• Ensure that the fuel is well mixed by shak-
ing the container before filling the tank.
Starting and stopping
WARNING:
Never start the blower
if the inlet cover is not closed, is
damaged or cannot be closed
(except if the vacuum
tube is fitted).
Cold
engine
Primer bulb:
Press the primer bulb 10
times until fuel begins to fill the bulb. The
primer bulb need not be completely
filled.
jZ
Choke:
Move the blue engine choke lever
over to the FULL CHOKE
(closed) position.
[14
Starting:
Hold the body of the machine
on
the ground using your left hand
CAUTION!
Not with your foot!).
Firmly grip the starter rope handle with
your right hand. DO NOT squeeze
throttle
trigger,
Slowly pull out the cord
until you feel some resistance
(the starter
pawls grip); then quickly
and powerfully
_ull the cord.
d_lb WARNING:
Never wrap the starter
cord around your hand.
Pull starter handle until engine attempts
to
run, but no more than 3 pulls. Move choke
to 1/, position
and pull the cord until the en-
gine starts and runs. Allow the engine to
warm
up for approximately
10 seconds;
then, move the choke to the OFF CHOKE
(opened)
position.
NOTE:
If engine dies, return blue engine
choke lever to the closed
position
and
repeat starting
steps.
CAUTION!
Do not pull the starter cord all
the way out and do not let go of the starter
handle when the cord is fully extended.
This can damage
the machine.
Warm
engine
With a warm engine,
squeeze
and hold the
throttle trigger. Move choke to 1/2position.
Pull starter rope sharply
while squeezing
throttle trigger until engine runs. Move the
choke to the OFF CHOKE
(opened)
position.
I+
Stopping
To stop the engine,
push and release
the
engine STOP switch
(S). The switch
will
automatically
return to the ON position.
Wait 7 seconds
before attempting
to restart
unit to allow switch to reset.
S
/
545186705
Rev. 3
7/1/08
English-12

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

125b x-series

Table of Contents