DeWalt DW328 Instruction Manual page 4

V,ithasa plug thatlooks l ikethatshown i nsketch A .Ifitisforuse
on150 to250 V,ithasaplug thatlooks like thatshown i nsketch D .
Anadapter, sketches BandC,isavailable forconnecting sketch A
type plugs to2-prong r eceptacles. The green-colored rigid ear,lug,
orthelike,extending f romtheadapter m ustbeconnected toa
permanent ground, such asa properly g rounded o utlet b ox.No
adapter is available f ora plugasshown insketch D.ADAPTER
SHOWN INFIGURES B andC ISNOTFOR USEINCANADA.
Useonly 3-wire extension cords t hathave 3-prong g rounding-type
plugs and 3-pole receptacles thataccept thetool's plug. R eplace or
repair damaged cords.
Inall casesmakesurethereceptacle i n question is properly
grounded. Never remove grounding prong f rom power plug.
A GROUNDED B C D
GROUNDING
BOX MEANS
I
GROUNDING PIN
ADAPTER
GROUNDING PIN
Additional Safety Rules - Portable Band
Saws
1. DISCONNECT PLUG from power supply before changing blades,
inspecting, cleaning or when saw is not being used.
2. KEEP HANDS AWAY from cutting area.
3. WHEN SAWING never reach underneath the material for any
reason.
4. KEEP BLADE SHARP. Dull blades may cause the saw to swerve
or staff under pressure.
5. IF YOU DROP THE SAW, unplug it first; then check aft external
parts including blade and blade guard. Repair or replace damaged
parts before using saw.
6. KEEP BLADE GUARD in place and in working order.
7. ALWAYS USE WORKSTOP.
8. NEVER OPERATE BAND SAW WITHOUT HOLDING IT WITH
BOTH HANDS.
9. Make sure that material to be cut is firmly held to prevent
movement.
10.Stay clear of end pieces that may fall after cutting off. They may be
hot and can seriously bum you.
11.Never use liquid coolants with portable band saws.
12. z_ WARNING: Exercise extreme caution when cutting blind into
conduit and pipe. Be sure the object being cut does not contain
electrical wires, gases, or water, etc., which could create
hazardous conditions causing personal injury and property
damage.
13. WEAR EAR PROTECTION to safeguard against possible hearing
loss.
14. z_ CAUTION: Wear safety glasses while using compressed air.
15. z_ WARNING: EXERCISE EXTREME CARE TO PREVENT
HANDS FROM CONTACTING THE BLADE.
16. z_CAUTION: Do not operate your tool on a current on which the
voltage is not within correct limits. Do not operate tools rated A. C.
only on D.C. current. To do so may seriously damage the tool.
SAVE THESE INSTRUCTIONS
CAUTION: When being used on job sites where arc or resistance
welding is being performed, the cord set on this tool could be
damaged by heavy welding currents using the cord as a parallel
return path. To maintain the protection the ground wire provides,
the cord should be inspected frequently and replaced as necessary.
Avoid unnecessary contact between the metallic exterior of the tool
and grounded conductive surfaces.