GE JTP56 Use And Care Manual page 37

QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM POSSIBLE CAUSE
• This is a function error code. Press CLEAR/OFF. Allow the oven to cool one
hour. Place the oven back into operation.
• Disconnect all power to the oven for 5 minutes and then reconnect power. If the
failure code repeats, call for service.
• This is reminding you to press BAKE or CONVECTION BAKE and then enter
ENTERI_ GCOOKING TIME a bake temperature. • :
OR DELAY: START TIME _ ;This is reminding you to enter a bake temperature after having pressed BAKE
or CONVECTION BAKE.
DISPLAY GOES BLANK: : • The Circuit breaker in your house has been tripped, or a fuse has been blown.
DISPLAY FLASHES • Power failure. Reset the clock.
, BAKE and BROIL HI/LO must be pressed at the same time and held for
2 seconds.
• The probe is not inserted properly into the oven receptacle or food.
0 This is reminding you to enter a probe temperature after plugging in the probe.
'%OCK DOOR" FLASHES • Oven door not closed after self-clean cycle is selected.
'_LOCKED DOOR" FLASHES ° Door is still locked and you are trying to enter an oven cooking operation.
L
The light bulb is loose or defective. Tighten or replace°
"The pad operating the oven light is broken. Call for service.
° Oven temperature is too high to set self-clean operation.
SELF-CLEAN Allow the oven to cool to room temperature and reset the controls_
• The probe is plugged into the outlet in the oven. Remove the probe from
: _ the oven.
OVEN NOT CLEAN: , Oven controls not Set properly. See the Operating the Self-Clenning
AF1T_.R CLEAN CYCLE Oven section.
, Heavily soiled ovens require 4 to 5 hours of clean time.
, Heavy spiltovers should be cleaned up before starting clean cycle.
DOOR WILL NOT • When the temperature has fallen below the locking temperature door can
OPEN Ab-q_R be opened.
(continued nexI page)
37