Removing Andreplacingthe Doors - GE GSS25LGMBBB Owner's Manual And Installation

Removing andreplacingthe doors.
lUllunnl u lU i i
When installing or moving the refrigerator, the doors may need to be removed in order to fit the refrigerator
through a doorway.
Removing the Doors
Make sure the doors are closed and the refrigerator
is unplugged.
0
Disconnect w ater line and wiring harness.
Near the lower hinge on the [reezer side, push in on the
collars at each end of the coupling, and pull the _ter
line tubing fi_om tire coupling Also, disconnect wiring
harness, Pull the water line and the harness through the
lower rail,
0 Remove the hinge covets and the hinges.
In order to access the hinges, the hinge covez_ need to
be removed. Remove the cover by grasping it on the sides,
near the back of the cover: Push back on the cover and
li/_ up at the back, then the front
NOTE:DONOTusea screwdriver to remove thecover. B ECAREFUL
nottobreaktherearretaining tab on thehingecover. R emove the
hinges usinga Terx T-20
0 Removethedeots.
Cme_tlly rotate the door to 90? Gtfiding the disconnected
_ter line mad wiring harness, lift the door straight up.
NOTE: Notrifting thedoorstraightup maydamage thebottomhinge
Place doorsona protected surface
NOTE" B ecarefulnot topinchthewater tubingand thewireharness
at thebottomof thedoor.
NOTE" D onot allow theconnector t o contact t hefloor,Hardcontact
candamagetheconnector, See "Replacing theDoors"
Replacing the Doors
Place doors on bottom hinges,
With the door at 90_ lowei the door' straight down onto
the bottom hinge. Carefully close the door.
@
0
NOTE: N ot lowenngthedoorstraightdownontothebottomhinge
may damagethehinge
NOTE: D onot allow theconnector t o contactthefloor.Hardcontact
candamage theconnector.
Replacetophingesand hinge covets.
Reinstall the top hinges using a Torx T-2& Replace the
hinge covers If the dool_ are not level, adjust the bottom
right hinge with a 7/16" open ended wrench.
Reconnect w ater line and wiring harness.
Insert water tubing back into coupling, making sttre fl_e
tubing is pushed far' enough into the coupling so that you
no longer see the ma, k on the mbing_ Reconnect the
wiring harness.
Turn on the water supply and plug therefrigerator backin.
Hinge Cover
Door
, Hinge Pin
\
Connector
16