Getting Connected - Zoom BFX-708 Operation Manual

Getting Connected

Bass
1
Use a monaural cable to connect the bass
to the INPUT jack of the BFX-708.
At this time, the amplifier power switch and the
power switch of the BFX-708 should be OFF.
2
Use a monaural cable to connect the
OUTPUT jack of the BFX-708 to the input
of the amplifier.
By using two amplifiers, you can get great
HINT HINT
stereo sound from stereo effects. Use a stereo
Y cable to connect the OUTPUT jack to the
two amplifiers.
V
A
POWER
ON OFF
3
To monitor the sound with headphones,
connect the headphones to the OUTPUT
jack.
4
Verify that the amplifier is turned off and
that the volume control is turned to
minimum. Also verify that the power switch
of the BFX-708 is set to OFF.
ZOOM BFX-708
INPUT DC9V
(AUX IN)
300mA
Monaural cable
Two bass amplifiers
Stereo Y cable
OUTPUT
(PHONES)
Monaural cable
Bass amplifier
OUTPUT
(PHONES)
POWER
ON OFF
Headphones
AC adapter
5
When using an AC adapter, plug the output
cable from the adapter into the DC 9V jack
on the BFX-708 and plug the adapter into
an AC outlet.
To guard against inadvertently disconnecting
HINT
HINT
the AC adapter cable, wind the cable once
around the hook on the rear panel of the BFX-
708.
6
Turn on power in the order BFX-708
amplifier (playback equipment).
7
Adjust the volume of the amplifier and the
BFX-708 to a suitable position while
playing the instrument.
The OUTPUT knob of the BFX-708 should be
set to about the 3 o'clock position, and the AMP
SIM knob should be set to the OFF position.
When the BFX-708 is in the bypass state (all
NOTE
effects are temporarily turned off; see page
10), the output level will be the same as the
input level if the OUTPUT knob is turned fully
clockwise.
OUTPUT AMP SIM
OFF
OFF
5