Getting Connected - Zoom 708II Bass Operation Manual

Getting Connected

CD player or similar
1.
Make sure that the amplifier and the
708II are off.
Turn the volume at the amplifier to minimum.
2.
To power the unit from the AC
adapter, insert the small plug of the
adapter cable into the [DC 9V] jack on
the 708II. Then plug the adapter into
an outlet.
3.
Connect the bass to the [INPUT] jack
of the 708II, using a mono cable.
4.
Connect the [OUTPUT/PHONES] jack
of the 708II to the bass amplifier,
using a mono cable.
You can also use a Y cable to supply the signal
in stereo to two amplifiers.
Bass
AC adapter
Bass amplifier
5.
To monitor the sound with headphones,
plug the phones into the [OUTPUT/
PHONES] jack.
6.
Turn power on in the following order:
708II → amplifier.
N
OTE
If you turn the 708II on while the amplifier is
already powered up, damage to the speaker may
result. Always turn power to the amplifier on last.
7.
Raise the volume setting of the
instrument and amplifier, and adjust
the [OUTPUT] knob on the rear panel
of the 708II.
Headphones
7
ZOOM 708II BASS