Effect Module 5: Reverb; Patch Level - Zoom 2020 Operation Manual

Effect Module 5: Reverb

This effect module includes three types of reverberation
effects.
REV1 (Reverb 1)
1
This effect simulates hall-type reverberation, adding rich
ambience to the sound.
Parameter 1
Parameter 2
Parameter 3
Explanation
(1)TIME: Determines the duration of the reverberation.
Higher values increase the reverb time and the apparent
room size.
(2)TONE: Determines the tonal quality of the
reverberation. The higher the value, the brighter the
sound.
(3)MIX: Determines the balance between effect sound and
direct sound.
E/R (Early Reflections)
2
This is a short, room-type reverb effect, which adds body
and ambience to the sound without causing excessive
boominess.
Parameter 1
Parameter 2
Parameter 3
Delay
3
This effect is similar to the ping-pong delay of the DELAY
module, but with a maximum delay time of 900
milliseconds.
Parameter 1 TIME (x10 ms)
Parameter 2 FEEDBACK
Parameter 3 MIX
Explanation
(1)TIME (x10 ms): This parameter adjusts the delay time
in 10-ms steps.
(2)FEEDBACK: Determines the number of repetitions of
the delay sound. The higher the value, the more
repetitions are added.
(3)MIX: Determines the balance between effect sound and
direct sound. At a setting of 0 (zero), the output signal
TIME 1 to 10
TONE -7 to +7
MIX 0 to 10
TIME 1 to 10
TONE -7 to +7
MIX 0 to 10
0 to 90
0 to 10
0 to 10
contains only the direct sound, and at a setting of 10 only
the effect sound.
When the 2020 is used in a monaural configuration,
NOTE
only short delay signals are output from the
OUTPUT L/MONO jack.
By combining this effect with the ping-pong delay of
HINT
the DELAY module, complex multiple delay effects
can be created.

Patch Level

Parameters 4 and 5 of the REVERB module serve to set the
patch level. This setting can also be stored as part of the
patch.
Parameter 4 PATCH LEVEL
Parameter 5 PATCH LEVEL
Explanation
(4)/(5) PATCH LEVEL: Determines the individual output
level for each patch.
The patch level parameter can be set regardless of
HINT
the REVERB module on/off status. It is also possible
to change the patch level in the Play mode.
When all modules are OFF, the PATCH LEVEL
setting "25" produces the same volume as in the
bypass mode.
0 to 31
0 to 31
17