Table of Contents
Advertisement
30 | Setting up Sharp MFP devices to use with Send to eCopy
Creating a profile that uses an FTP folder
When you configure the MFP device, you specify information about the target FTP site and the
authorized FTP user in a profile.
Make sure that you have the device's IP address before you begin.
To configure the MFP:
Open a Web browser.
1
2
In the Address bar, type the Internet address (URL) for the device you want to connect to,
using the format
page opens.
3
Under
Image Send Management
Log in to the device.
4
5
Under
New Destination
Under
6
FTP Destination Control
required by Send to eCopy, in addition to any information that is required by the device:
Hostname or IP Address
Note:
To use this profile with Send to eCopy, you must enter user name, password, and
directory information, even though the screen indicates that the fields are optional.
User Name
— Enter the name of the FTP user created to access the FTP site, such as:
.
FTPeCopy
Password
— Enter the password of the FTP user.
— Enter the path to the target FTP folder created for temporary storage of the
Directory
scanned image files, such as:
Click
. When the "Your request was successfully processed" message appears, the
7
Submit
configured profile is available at the device.
http://device_IP_address
, click
, click
FTP
.
, make sure that you specify the following information, which is
— Enter the address of the FTP site, such as:
\scans
or
, and then press E
Destination
.
\scans\HR
.
. The System Information
NTER
10.10.12.110
.
Advertisement
Table of Contents
