Connecting Auxiliary Equipment; Connecting The Ac Power Cord; Connect The Headphone; Turning The Power On And Off - Hitachi AX-M70MP3 Instruction Manual

Connecting Auxiliary Equipment

Connecting Auxiliary Equipment
Connecting Auxiliary Equipment Connecting Auxiliary Equipment Connecting Auxiliary Equipment
Connect signal cords between the AUX input terminals on the amplifier and the output terminals
of your auxiliary equipment.

Connecting the AC Power Cord

Connecting the AC Power Cord
Connecting the AC Power Cord Connecting the AC Power Cord Connecting the AC Power Cord
Insert the AC power cord into a wall outlet, and your system is at your command!
C a u t i o n : C a u t i o n : C a u t i o n : Be sure to unplug the power cord from the outlet when going out or when the system
C a u t i o n : C a u t i o n :
is not in use for an extended period of time.

Connect the Headphone

Connect the Headphone Connect the Headphone Connect the Headphone Connect the Headphone
Connect a pair of headphones to the phones jack. No sound comes out of the speakers.
Note: Note: Note: Be sure to turn down the volume before connecting or putting on headphones. Note: Note:
T T T T T urning the P urning the P urning the P
urning the P urning the Power On and Off
T T T T T urning the System On urning the System On urning the System On urning the System On urning the System On
Press the standby button (STANDBY) to turn the system on from standby mode. The display
comes on.
C a u t i o n : C a u t i o n :
C a u t i o n : C a u t i o n : C a u t i o n : When turning the system on, the system comes on ready to continue in the mode it
was in when last turned off.
T T T T T urning the System Off urning the System Off urning the System Off
urning the System Off urning the System Off
Press the standby button (STANDBY) again to turning the system off (called Standby Mode).
C a u t i o n : C a u t i o n : C a u t i o n : Be sure to unplugging the system from the wall output when going out or when the
C a u t i o n : C a u t i o n :
system is not in use for an extended period of time.

Installation of Batteries in the Remote Control

Installation of Batteries in the Remote Control Installation of Batteries in the Remote Control
Installation of Batteries in the Remote Control Installation of Batteries in the Remote Control
1. Remove the battery compartment cover.
2. Insert two batteries (size AAA) correctly so that the + and - polarities match the polarity
diagrams in the battery compartment.
* About half a year of normal operation can be expected when using the general batteries.
* When the batteries are exhausted, the remote will no longer operate the system. Replace
both batteries at the same time with new ones.
* Don't use an old battery with a new one.
* Don't use different types of batteries together.
* When the remote is not to be used for a long time period of time, remove the batteries to
avoid damage caused by battery leakage and corrosion.
ower On and Off ower On and Off
ower On and Off ower On and Off
Auxiliary equipment
- 6 -